fasadthree.blogg.se - Cisco ios xe gibraltar vs fuji

#CISCO IOS XE GIBRALTAR VS FUJI SOFTWARE#
#CISCO IOS XE GIBRALTAR VS FUJI LICENSE#
#CISCO IOS XE GIBRALTAR VS FUJI SERIES#

Switch(config-if-range)#ptp sync interval -2 Switch(config-if-range)#spanning-tree portfast trunk Switch(config-if-range)#switchport mode trunk Switch(config)#interface range GigabitEthernet1/0/1 - 24 The following is an example for configuring all ports 1-24 using the interface range command: Set PTP sync interval to be suitable for AVB end points.Įnsure the port is not administratively shut down.Įnd configuration mode and return to EXEC mode.Ĭonfiguring port by port is time consuming. Interface moves directly to spanning-tree forwarding state Switch(config-if)# spanning-tree portfast t runk Switch(config)# interface GigabitEthernet1/0/1 The following commands show enabling trunk mode for interface GigabitEthernet1/0/1. The port must also not be administratively shutdown. Step 2 - Configure interfaces with AVB connections to VLAN trunk mode.Īny ports with AVB devices attached must be configured for VLAN trunking mode. In these cases, VLAN 2 (or any nominated VLAN) can be configured manually and MVRP not utilized.īiamp AVB devices will honor what is requested by the switch.įor further details, see the Cisco IOS XE command reference guide for configuring Audio Video Bridging. MSRP optimization command requested by CiscoĮnd global configuration mode and return to EXEC mode.Īutomatic VLAN creation may not be preferred some environments. QOS increase this buffer requested by Cisco Switch(config)# qos queue-softmax-multiplier 1200 Set MSRP leave-all timer to expected value Switch(config)# avb msrp-leaveall-timer 25000 Switch(config)# avb msrp-leave-timer 1200 VLAN Trunking Protocol (VTP) can be configured for off or transparent mode operation. Default VLAN 1 must be enabled on AVB portsĮnter the following commands to enable AVB and MVRP (automatic VLAN) on the switch.Interfaces are not configured for Etherchannel.User has access to CLI with configure permissions.

#CISCO IOS XE GIBRALTAR VS FUJI LICENSE#

Switches have appropriate license levels.

#CISCO IOS XE GIBRALTAR VS FUJI SOFTWARE#

Cisco IOS XE Software with AVB support.

IOS XE Amsterdam-17.3.3 for the Catalyst 9000 family.

IOS XE Gibraltar-16.12.5b for Catalyst 3000 family.

DNA Subscription license not required for AVB support.Ĭisco recommends the following Cisco IOS® XE Software release versions are required for AVB support.

Network Advantage for Catalyst 9000 family.

ipbase or ipservices license level for Catalyst 3000 family.

The following Cisco license levels are required for AVB support.

#CISCO IOS XE GIBRALTAR VS FUJI SERIES#

C9300-48UN only ports 1-36, 38 support PTP.Ĭatalyst 36 series switches have been certified by the Avnu Alliance.Ĭatalyst 93 series switches have been certified by the Avnu Alliance.NOTE: The following Cisco models PTP is not supported on all ports. Please always reach out to Cisco Support regarding information about their latest software updates. Please always check Cisco AVB for updates on their current models. AVB is supported on select models of the following Catalyst series.